Starrett - Saws & Hand Tools

KWIK-CHANGE | ARBOR

• Attach the arbors to all regularly used hole saws. • Change between different sizes of saw at the push of a button!

Push the button on the arbor and pull the hole saw down the pilot drill. To use a new hole saw, push the button on the arbor and slide the hole saw forward to remove it.

KWIK-CHANGE | PILOT DRILL

• Pull back the chrome collar on the chuck to change the pilot drill. • No tools required! • Caution: Pilot drills may be hot after use.

Pull back the collar on the chuck to remove the pilot drill, to insert a new drill pull back the collar on the chuck and insert the new drill.

• Attach arbors to hole saws of the same size as the existing hole and the same size as the required hole. • Attach the larger diameter hole saw to the Kwik-Change chuck. • Attach the smaller diameter hole saw to the drill and slide it down inside the larger diameter saw. • Drill the hole. This system is recommended for overhead or vertical surfaces only. KWIK-CHANGE | HOLE ENLARGEMENT

Attach the larger hole saw to the chuck, slide the smaller of the two hole saws inside the larger hole saw and use it as a pilot for the new, larger hole.

KWIK-CHANGE | CORE EJECTION

• If the core is stuck in the hole saw after drilling a hole, press the arbor button and slide the hole saw and attached arbor off the drill. • The pilot drill can then be used to push the core out of the saw using the side flutes or the holes in the base of the saw. • Caution: Cores may be hot and sharp.