Hole Enlargement Arbor Replacing the pilot drill on your arbor, the KA19 allows diameters to be enlarged by attaching a saw of the same size to that of the existing hole. This saw then acts as the pilot for the larger diameter saw that is attached to the arbor.
KA19
Please note: Hole Saws and Arbor are supplied separately.
Cat. No.
Item Number
Minimum Hole Enlargement
KA19
AY228
4.7mm (3/16”) between pilot hole saw and cutting saw diameter.
DEBRIS COLLECTOR No Clean Up - No Drill Damage - No Debris Spread FEATURES:
Cat No Item Number
Description
DB2
AY2835
Debris Collector
• Bowl flexes with minimal pressure as the hole is sawn. • Huge potential time saving - there is no need to mask at risk areas prior to sawing or clean up after sawing.
• Keeps dust and other debris out of the motor of the drill. • Suitable for hole saws up to and including 121mm (4 3/4”).
STAGE ONE
STAGE TWO
• STAGE ONE | Pass the shank of the arbor through the hole at the bottom of the DB2 and attach to the drill in the normal way. Always ensure that the Debris Collector spins freely prior to use. • STAGE TWO | Site the saw for cutting the hole. The Debris Collector can be pulled down to provide a better view of the work area. • STAGE THREE | Drill the hole. • STAGE FOUR | All the dirt and debris from the cut hole is collected inside the Debris Collector.
STAGE THREE
STAGE FOUR
22
Powered by FlippingBook