Systems
S2 Systems
When you need an easy-to-use measurement system for accurately and precisely determining spring rates, spring constants, spring lengths and other spring characteristics, Starrett S2 systems are the solution. S2 systems are ideal for high- volume production testing, quality control including incoming inspection verification and validation, and research and design engineering. S2 systems may be used for compression and extension springs with load ratings up to 11,000 lbf (50 kN, 5000 kgf). Our simple, fill-in-the-blank test setups let you test and validate your springs in as few as three steps allowing your testing to be performed in seconds. In addition, your test results can be viewed, graphed and reported, including the ability to export results or raw data at rates up to 1000Hz.
Test Setup Options
Pre-Test Options
• Units of Measurement • User Prompts to assist operator during testing • Spring preconditioning (Scrag and Load Set Hold for duration) Test Options • Measure Free Length • One Point Limit Test (Load or Height) • Two Point Limit Test (Load and/or Height) • Exceptions (Abort test if an exception is met) Data Options • Spring Constant (One Point) • Spring Rate (Two Point) • Date, User, Limit Setpoints Post-Test Options • Export Raw Data to a file location (up to 1000 samples/second) • Export Results (Overwrite or Append data file) Test Methods • Spring Constant • Spring Rate
• Initial Tension • Free Length • Load @ Height/Lengths • Single Point • Two Point • Multiple Points • Height/Length @ Loads • Single Point • Two Point • Multiple Points • Scragging and Load Hold Set
S2 systems can use any FMS, FMD, MMS or MMD test frame. Shown is an S2 system using an FMS-5000 test frame.
22
Powered by FlippingBook